Skip to main content

System Testing and Validation

Jim Parker
  1. Open cloud access
  2.  
  3. Open Brand sites 
  5. Open location you are working on
  7. Energy: validate readings are correct
  9. HVAC: Names for each thermostat is correct 
  10. HVAC: Space Temperatures are correct
  11. HVAC: Setpoints are correct
  12. HVAC: Discharge temperatures are correct, Temperatures dropping while in cooling, Rising while in heating
  13. HVAC: Unit is in Auto Mode
  14. HVAC: Fan mode is ON for kitchens and Auto for remaining units
  15. HVAC: Schedules are set for each unit
  17. Lighting: Lighting zone name is correct
  18. Lighting: Validate current mode of lights, Yellow= ON Grey= Off. check to see if lights are actually on or off 
  19. Lights: Tests lighting control by toggling the lights on and off 
  20. Lights: Set lighting Schedules
  22. Refrigeration: Names for walk-in units are correct
  23. Refrigeration: All temperature values showing
  24. Refrigeration: In cooling mode coil temperature is dropping below room temperature  
  25. Refrigeration: In defrost mode Coil temperature is above room temperature
  26. Refrigeration: All Remote Temp sensors are showing values consistent to placement
  27. Refrigeration: Set temperature is set for each sensor
  28. Refrigeration: Names are Correct for each sensor
  30. Temperatures: All Sensors are showing in page 
  31. Temperatures: All Names are correct
  32. Temperatures: All sensors are reporting values according to the location of the sensor 
  33. Temperatures: Set points are set for each sensor

Comments

0 comments

Article is closed for comments.